Termék leírás
The Spark R&D Dyno DH is acclaimed hardboot specific splitboard binding. It is designed to fit a variety of touring boots from different brands and delivers high-end performance to the growing hardboot segment of splitboarders. All parts are designed and manufactured by Spark R&D from start to finish for the all-around precision that you can only get from a Spark made product. Dyno DH Bindings are meant for riding only. Carry them in your pack on the way up, while using your Tech Toes, Hardboot Dual Height Wires and D Rex Crampons (if needed) for touring. Then slide the Dynos on your pucks and lock into place with the snap ramps for the ride down. Fits boots with 255 - 340 mm sole length.
Compatibility and Setup: Spark Puck compatible (Spark Canted Pucks recommended), also compatible with Spark Solid Board Pucks and Canted Solid Board Pucks.
Suggested equipment: Spark Tech Toes, Hardboot Dual Height Wires, D Rex Crampons, Dynafit Adapters, Canted Pucks
Features:
- Specially developed for hardboots
- For downhill riding only (for the climb use Tech Toes, Hardboot Dual Height Wires and D Rex Crampons)
- Suitable for: Expert users
- High-end splitboard binding that combines reactivity, performance and lightness
- Toe Clips - the toe clip is designed to fit even low profile AT boots. The slim design saves weight while maintaining backcountry dependability
- Set Screw - the set screw has a 4mm hex drive, found on the Spark Tool
- Lightweight & Strong - stainless steel bails and anodized aluminum toe clips. The heel end of the baseplate has been reinforced to avoid bending with heavy use
- Snap Ramps - Tesla System Snap Ramps for speedy, pinless transitions
- Weight: 818g (for pair)