The Spark R&D Dyno DH is acclaimed hardboot specific splitboard binding. It is designed to fit a variety of touring boots from different brands and delivers high-end performance to the growing hardboot segment of splitboarders. All parts are designed and manufactured by Spark R&D from start to finish for the all-around precision that you can only get from a Spark made product. Dyno DH Bindings are meant for riding only. Carry them in your pack on the way up, while using your Tech Toes, Hardboot Dual Height Wires and D Rex Crampons (if needed) for touring. Then slide the Dynos on your pucks and lock into place with the snap ramps for the ride down. Fits boots with 255 - 340 mm sole length.

Compatibility and Setup:  Spark Puck compatible (Spark Canted Pucks recommended), also compatible with Spark Solid Board Pucks and Canted Solid Board Pucks.

Suggested equipment: Spark Tech Toes, Hardboot Dual Height Wires, D Rex Crampons, Dynafit Adapters, Canted Pucks

Features:

• Specially developed for hardboots
• For downhill riding only (for the climb use Tech Toes, Hardboot Dual Height Wires and D Rex Crampons)
• Suitable for: Expert users
• High-end splitboard binding that combines reactivity, performance and lightness
• Toe Clips - the toe clip is designed to fit even low profile AT boots. The slim design saves weight while maintaining backcountry dependability
• Set Screw - the set screw has a 4mm hex drive, found on the Spark Tool
• Lightweight & Strong - stainless steel bails and anodized aluminum toe clips. The heel end of the baseplate has been reinforced to avoid bending with heavy use
• Snap Ramps - Tesla System Snap Ramps for speedy, pinless transitions
• Weight: 818g (for pair)

Reviews

* The content and opinions expressed by users reflect their personal views and do not represent the positions of PR, d.o.o. PR, d.o.o. does not assume responsibility for the accuracy and credibility of user statements.

Write review